This morning, with Manar and Aurélien, we measure the power directly at the output of the Alphanov amplifier.
(we had to remove the base plate where the deflector mirrors were mounted to put the large powermeter).

with the previously described procedure, it seems that the Alphanov software is now working and we were able to start immediately the amplifier.

the chiller temperature was set at 25°C but we saw in the Alphanov documentation that the chiller temperature was closer to 20°C.
we did several measurements at 25°C and 20°C and it doesn't change a lot the output power.
so, we set the temperature to 23°C to avoid condensation (if too cold).
we will ask Guillaume what is the best temperature for the chiller.

power measurements:
power ratio     =>   measured output power (with external powermeter, not with the software)
10%               =>               1W
20%               =>               9W
30%               =>               17.6W
40%               =>               26.4W
50%               =>               34.5W
60%               =>               42.5W
70%               =>               49.3W
80%               =>               56.6W
90%               =>               63.6W
100%             =>               ~70W (expected value, not measured)

we stopped the measurements at 90% as we observed a difference in the software between the expected values (previously recorded by Alphanov) and the present ones.
the present values are quite bigger than the ones measured by Alphanov.
Aurélien will call Guillaume to check if it is a problem or not.