************************** The work in this report is done in the Minicavity clean room ***************************

Location: Minicavity Clean Room

1. On 14/01/2021
   • Installation of the minicavity base (reference plate) (First attempt)
   • People: Yann, Carmelo and Manar (Guided by Aurélien from afar)

   • There was an issue with the holes for the screws (they were smaller than the original design)

2. On 26/01/2021
   • Installation of the minicavity base (reference plate) (Second and Last attempt)
   • People: Yann, Manar (Guided by Aurélien from afar)
   • The arrival of the new corrected plate. Installation went smoothly without issues.
   • **** Note: Need to check the correct placement of the plate.
3. On 01/02/2021
   • Update on the status of the plate
   • a picture of the placement of the plate is attached, it shows that it needs adjustment
   • a schematic of the plate is attached
     The plane mirrors must be spaced 88 mm apart and the spherical ones are 88.7 mm apart.
   • ****note: the cables for the motors are not connected yet. 

*****Note: The phone was cleaned thoroughly with the duster and ethanol before taking it into the clean room.